FOSHAN QI ALUMINUM DECORATIVE MATERIALS CO.,LTD
Shiquan Tiekeng Industrial, Nanhai Area, Foshan, Guangdong Province, China
0086 13542961174
info@aluminum-panel.com
0086 13542961174
Aluminum veneer is mainly used for the decoration of exterior walls of high-rise buildings, indoor ceiling and walls, etc. It is a kind of high-grade new building materials often used in modern decoration industry. However, only high-quality aluminum veneer can highlight its decorative effect, and high-quality aluminum veneer in the production process to pay attention to all the details. So, what are the precautions in aluminum veneer processing?
1. As a kind of high-grade decorative material, the production and processing level of domestic fluorocarbon spraying aluminum veneer manufacturers are greatly different. Before ordering aluminum veneer, we should pay special attention to the investigation of aluminum veneer manufacturers, the production capacity and scale of the manufacturers, engineering performance, and focus on the investigation of its technical design ability. Must not because the price is low and adopt the technical level is not high, the scale small processing factory, otherwise will bring the greater difficulty to the construction project and the management, the consequence will cause the irreversible economic loss.
2. As an important process before the processing of fluorocarbon sprayed aluminum veneers -- field data measurement, it is recommended to use infrared range finder for measurement. If the traditional measuring tape is used, there will be measurement error, which will bring adverse effect to the aluminum veneer required to be stitched and spliced.
3, in the processing of fluorocarbon spraying aluminum veneer, should not be a one-off will all aluminum processing molding, each installation area should be the final piece of the aluminum plate and bottom plate no processing, all stay in the area of fluorocarbon spraying aluminum veneer after the installation, field data measured again, get accurate size and processing, in order to avoid unnecessary rework and economic losses.
4. Fluorocarbon coated aluminum veneer is a kind of metal decorative plate, but its fluorocarbon coated layer is easy to scratch. Therefore, in addition to the requirements of manufacturers aluminum veneer with protective film into the field, in the process of handling and installation should also focus on avoiding scratches and heavy impact, otherwise it will seriously affect the overall appearance of aluminum veneer.
5. The installation process of aluminum veneer also affects the decorative effect of aluminum veneer to a large extent. In order to ensure that the high-grade decorative effect of the entire aluminum veneer can be well reflected, the precautions in the processing of aluminum veneer shall be well done, and the subsequent installation process shall also use good installation personnel
